Nekochan Net

Official Chat Channel: #nekochan // irc.nekochan.net
It is currently Fri May 24, 2013 2:13 am

View unanswered posts | View active topics View unread posts


Board index » SGI » SGI: Hardware

All times are UTC - 8 hours


Forum rules


Any posts concerning pirated software or offering to buy/sell/trade commercial software are subject to removal.



Post new topic Reply to topic  Page 1 of 4
  [ 46 posts ]  Go to page 1, 2, 3, 4  Next
  Print view Previous topic | First unread post | Next topic 
Author Message
Oskar45
Unread postPosted: Sat Jul 29, 2006 6:18 am 
Offline
User avatar

Joined: Mon Dec 05, 2005 2:35 am
Posts: 1919
Location: Vienna, Austria
I normally leave my Fuel run 24x7; however, the other day when I came home it was down and after reboot, I'd found in syslog:
Quote:
unix: |$(0x15a)WARNING: 001a01 ATTN: 1.5V low warning limit reached @ 1.340V.
unix: |$(0x15a)WARNING: 001a01 ATTN: 1.5V low warning limit reached @ 1.269V.
unix: |$(0x160)WARNING: 001a01 ATTN: 1.5V level stabilized @ 1.452V.
unix: |$(0x15a)WARNING: 001a01 ATTN: 1.5V low warning limit reached @ 1.255V.
unix: |$(0x160)WARNING: 001a01 ATTN: 1.5V level stabilized @ 1.354V.
unix: |$(0x158)WARNING: 001a01 ATTN: 1.5V low fault limit reached @ 1.199V.
unix: WARNING: Auto power down will be delayed until shutdown is complete.
unix: |$(0x163)WARNING: 001a01 ATTN: power down aborted, environmental monitor reset
Xsession: mephisto: logout
INFO: The system is shutting down.
INFO: Please wait.
4D:IRIS /usr/etc/eventmond[794]: The child process was killed by the signal 9
0D:IRIS inetd[265]: inetd received SIGTERM; terminating.
3F:IRIS syslogd: going down on signal 15

What in your opinion is the exact reason for that? Can I do anything about it?
Top
 Profile  
 
hamei
Unread postPosted: Sat Jul 29, 2006 6:39 am 
Offline

Joined: Tue Feb 24, 2004 4:10 pm
Posts: 8349
Location: waist deep in the Big Muddy
Oskar45 wrote:
I normally leave my Fuel run 24x7; however, the other day when I came home it was down and after reboot, I'd found in syslog:

Code:
unix: |$(0x15a)WARNING: 001a01 ATTN: 1.5V low warning limit reached @  1.340V.
unix: |$(0x15a)WARNING: 001a01 ATTN: 1.5V low warning limit reached @  1.269V.
unix: |$(0x160)WARNING: 001a01 ATTN: 1.5V level stabilized @  1.452V.
unix: |$(0x15a)WARNING: 001a01 ATTN: 1.5V low warning limit reached @  1.255V.
unix: |$(0x160)WARNING: 001a01 ATTN: 1.5V level stabilized @  1.354V.
unix: |$(0x158)WARNING: 001a01 ATTN: 1.5V low fault limit reached @  1.199V.

What in your opinion is the exact reason for that?

Mainboard monitoring failure ...
Quote:
Can I do anything about it?

You have a service contract. Get a new one. In the meanwhile < l1cmd env off > will get you back running. That's what us normal mortals have to do :) The environment monitoring on Fuel sucks. SGI probably lost plenty of money by cheapying out on the components there. Save a nickel, lose a dollar MBA-think. Oops.
Top
 Profile  
 
Oskar45
Unread postPosted: Sat Jul 29, 2006 9:57 am 
Offline
User avatar

Joined: Mon Dec 05, 2005 2:35 am
Posts: 1919
Location: Vienna, Austria
hamei wrote:
You have a service contract. Get a new one.

Heh, hamei, you really recall that I've a service contract!!! Congrats to your brain - should be preserved in some nicely-labelled jar!!! Anyway, I'll be fine with a new board in a few days. Don't want to think about what it oost me without contract, though!
Top
 Profile  
 
hamei
Unread postPosted: Sat Jul 29, 2006 10:27 am 
Offline

Joined: Tue Feb 24, 2004 4:10 pm
Posts: 8349
Location: waist deep in the Big Muddy
Oskar45 wrote:
hamei wrote:
You have a service contract. Get a new one.

Heh, hamei, you really recall that I've a service contract!!! Congrats to your brain - should be preserved in some nicely-labelled jar!!!

It was, originally. Abby something ...
Top
 Profile  
 
zafunk
 Post subject:
Unread postPosted: Mon Jul 31, 2006 5:51 am 
Offline
User avatar

Joined: Thu Feb 12, 2004 11:51 pm
Posts: 1060
Location: Victoria, BC, Canada
I had the same problem recently and had to kill the environmental monitoring. I don't have a contract though :(
Top
 Profile  
 
unixmuseum
Unread postPosted: Mon Jul 31, 2006 6:03 am 
Offline

Joined: Mon Apr 19, 2004 3:25 pm
Posts: 2783
Location: Los Angeles, CA
hamei wrote:
It was, originally. Abby something ...
:-D :-D :-D
Top
 Profile  
 
Oskar45
 Post subject:
Unread postPosted: Mon Jul 31, 2006 6:26 am 
Offline
User avatar

Joined: Mon Dec 05, 2005 2:35 am
Posts: 1919
Location: Vienna, Austria
zafunk wrote:
I had the same problem recently and had to kill the environmental monitoring.

Hmm, I'm not sure that killing env monitoring will save you. As I've noted in my original post of this thread, the messages are written by the kernel so they will be in the syslog even if eventmond is not running. Also, I suspect my box would have been killed anyway regardless of whether eventmond was running or not ...
Top
 Profile  
 
zafunk
 Post subject:
Unread postPosted: Mon Jul 31, 2006 6:36 am 
Offline
User avatar

Joined: Thu Feb 12, 2004 11:51 pm
Posts: 1060
Location: Victoria, BC, Canada
Oskar45 wrote:
Hmm, I'm not sure that killing env monitoring will save you. As I've noted in my original post of this thread, the messages are written by the kernel so they will be in the syslog even if eventmond is not running. Also, I suspect my box would have been killed anyway regardless of whether eventmond was running or not ...


Hmm.... well, only time will tell. So far, turning the monitoring off has saved me, but I may have to get a new mobo eventually :(
Top
 Profile  
 
nekonoko
 Post subject:
Unread postPosted: Mon Jul 31, 2006 7:40 am 
Offline
Site Admin
Site Admin
User avatar

Joined: Thu Jan 23, 2003 1:31 am
Posts: 7947
Location: Pleasanton, California
Oskar45 wrote:
zafunk wrote:
I had the same problem recently and had to kill the environmental monitoring.

Hmm, I'm not sure that killing env monitoring will save you. As I've noted in my original post of this thread, the messages are written by the kernel so they will be in the syslog even if eventmond is not running. Also, I suspect my box would have been killed anyway regardless of whether eventmond was running or not ...


If you're shutting off env monitoring on the L1 (which is the case here) it won't report anything to the kernel. No-one said anything about turning off eventmond - this is more low level :)

_________________
Twitter: @neko_no_ko
IRIX Release 4.0.5 IP12 Version 06151813 System V
Copyright 1987-1992 Silicon Graphics, Inc.
All Rights Reserved.


Top
 Profile  
 
hamei
 Post subject:
Unread postPosted: Mon Jul 31, 2006 4:56 pm 
Offline

Joined: Tue Feb 24, 2004 4:10 pm
Posts: 8349
Location: waist deep in the Big Muddy
zafunk wrote:
Hmm.... well, only time will tell. So far, turning the monitoring off has saved me, but I may have to get a new mobo eventually :(

Going on two years now here .... if it finally dies it'll go into the scrapper. The Fuel just isn't that great a computer to spend SGI's version of money on.
Top
 Profile  
 
yetanother**ixuser
 Post subject:
Unread postPosted: Mon Jul 31, 2006 9:18 pm 
Offline
User avatar

Joined: Fri May 21, 2004 3:47 am
Posts: 372
Location: Linz/Austria
agreed :twisted:
Top
 Profile  
 
foetz
 Post subject:
Unread postPosted: Tue Aug 01, 2006 10:06 am 
Offline
User avatar

Joined: Mon Apr 14, 2003 3:34 am
Posts: 4651
hamei wrote:
zafunk wrote:
Hmm.... well, only time will tell. So far, turning the monitoring off has saved me, but I may have to get a new mobo eventually :(

Going on two years now here .... if it finally dies it'll go into the scrapper. The Fuel just isn't that great a computer to spend SGI's version of money on.


yes, sadly the fuel was more sort of a mips-pc like the alpha-pc those days or the 604e based ibms.

_________________
r-a-c.de
Top
 Profile  
 
hamei
 Post subject:
Unread postPosted: Tue Aug 01, 2006 4:15 pm 
Offline

Joined: Tue Feb 24, 2004 4:10 pm
Posts: 8349
Location: waist deep in the Big Muddy
foetz wrote:
yes, sadly the fuel was more sort of a mips-pc like the alpha-pc those days or the 604e based ibms.

Didn't mean to come off as quite so negative about the Fuel - it's not a bad computer, actually. It's just that SGI still had their heads up their asses when they priced it. Okay, the mainboard and cpu are low-volume high-cost items. But $600 for an off-the-shelf peecee case ? The exact same one they used in the 230 and 330 machines ? And the rest of their Fuel prices are equally nonsensical. No wonder they are bankrupt. No one who isn't a fanboy (us) is gonna spend six times what something is worth just because it says SGI on the outside. And then they shit on their fanboy constituency. Great.
Top
 Profile  
 
Dr. Dave
 Post subject:
Unread postPosted: Tue Aug 01, 2006 4:30 pm 
Offline
User avatar

Joined: Fri Feb 13, 2004 10:37 pm
Posts: 2311
Location: Ottawa, Canada >burp<
You know, it sounds like these monitoring boards can probably be fixed... judging by what Oskar posted earlier, looks like it may be capacitors or something oscillating in the buffer amps. Anyone got a really good clear picture (IC part number readability is good) of what one looks like, working or not?

_________________
:O3000: <> :O3000: :O2000: :Tezro: :Fuel: x2+ :Octane2: :Octane: x3 :1600SW: x2 :O2: x2+ :Indigo2IMP: :Indigo2: x2 :Indigo: x3 :Indy: x2+

Once you step up to the big iron, you learn all about physics, electrical standards, and first aid - usually all in the same day
Top
 Profile  
 
Oskar45
 Post subject:
Unread postPosted: Wed Aug 02, 2006 5:15 am 
Offline
User avatar

Joined: Mon Dec 05, 2005 2:35 am
Posts: 1919
Location: Vienna, Austria
nekonoko wrote:
Oskar45 wrote:
zafunk wrote:
I had the same problem recently and had to kill the environmental monitoring.

Hmm, I'm not sure that killing env monitoring will save you. As I've noted in my original post of this thread, the messages are written by the kernel so they will be in the syslog even if eventmond is not running. Also, I suspect my box would have been killed anyway regardless of whether eventmond was running or not ...


If you're shutting off env monitoring on the L1 (which is the case here) it won't report anything to the kernel. No-one said anything about turning off eventmond - this is more low level :)

Hmm - does that mean, if you shut off monitoring on the L1, the box would not die even if the voltage gets too low???
Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  Page 1 of 4
  [ 46 posts ]  Go to page 1, 2, 3, 4  Next

Board index » SGI » SGI: Hardware

All times are UTC - 8 hours


Who is online

Users browsing this forum: No registered users and 1 guest

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group