Curse you wiki! I can no longer be a smartass know-it-all!
Code: Select all
-bash-4.0# hinv -vm
CPU: MIPS R12000 Processor Chip Revision: 2.3
FPU: MIPS R12010 Floating Point Chip Revision: 0.0
1 270 MHZ IP32 Processor
Main memory size: 640 Mbytes
Secondary unified instruction/data cache size: 1 Mbyte on Processor 0
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
FLASH PROM version 4.18
Integral SCSI controller 0: Version ADAPTEC 7880
Disk drive: unit 2 on SCSI controller 0 (unit 2)
CDROM: unit 4 on SCSI controller 0
Integral SCSI controller 1: Version ADAPTEC 7880
CDROM: unit 5 on SCSI controller 1
PCI SCSI controller 2: Version ADAPTEC 7880
On-board serial ports: tty1
On-board serial ports: tty2
On-board EPP/ECP parallel port
CRM graphics installed
Integral Ethernet: ec0, version 1
Iris Audio Processor: version A3 revision 0
PCI Adapter ID (vendor 0x9004, device 0x8078) PCI slot 1
PCI Adapter ID (vendor 0x9004, device 0x8078) PCI slot 2
PCI Adapter ID (vendor 0x9004, device 0x8178) PCI slot 3
Video: MVP unit 0 version 1.4
AV: AV1 Card version 1, O2Cam type 1 version 0 connected.
Graphics board 0 is "CRM" graphics.
Managed (":0.0") 1440x900
32 + 32 bitplanes
board revision 2, CRM revision C, GBE revision B
Monitor 0 type: FUS 1808
Origin = (0,0)
Video Output: 1440 pixels, 900 lines, 60.00Hz (1440x900_60)
[[C|-|E]] wrote:Thank you guys!
I just cleaned the plastics in the shower, with soft liquid soap and an sponge. It seems that I was lucky with most of the plastics, although I had to replace some of them .
Users browsing this forum: No registered users and 0 guests