Code: Select all
[notice] 0 CoMsgLogger.cpp:109 08/10/17:04:30:48.755 Command line: '/usr/discreet/sw/sw_config'
[notice] 0 swc_disk_config_screen.C:3314 08/10/17:04:30:58.915 Requesting filesystem creation on partition 0 .
[notice] 0 swc_disk_config_screen.C:3722 08/10/17:04:30:59.848 Partition 0 inode count: 140012
[notice] 0 swc_disk_config_screen.C:3729 08/10/17:04:30:59.848 Partition 0 RAM usage: 44805120 bytes (42.73 MB)
[warn] 0 swc_disk_array.C:1093 08/10/17:04:30:59.851 Some partitions have no parity disk.
[error] 0 swc_disk_config_screen.C:2363 08/10/17:04:31:01.169 Saving device information failed. ioctl SWR SET CONFIG failed for partition 0 (/dev/swr00)
Partition 7 of disk 0 has zero blocks.
Basically I cloned my Tezro HDD and put that and my stonefs drive (the 2nd disk in the Tezro) away for safe keeping. I am using the cloned drive with no problems and I put a new bigger drive into the Tezro to use as a stonefs. sw_config keeps erroring out with the "partition 7 of disk 0 has zero blocks".
I uninstalled stone+wire, removed the "/usr/discreet/sw" dir (basically all that was left in it was my backed up configs and logs), then reinstalled stone+wire and I get the same error.
sw_config repartitions the drive if its not partitioned correctly - partition 7 is there, I can also make a xfs filesystem on it and mount it no problem. I was hoping to avoid doing a complete uninstall and fresh install of the discreet stuff, perhaps someone might have some insight?