Ive been using brl cad on my sgi gear. Kinda works but documentation is not the best.
I looked at qcad, not quite what i am looking for. For a quick design of a gear or something simple it does do the job.
Ive been on the lookout for autocad for irix, ive seen R13 does exist for irix, i even bought some books for R13, however yet to find the actual software with a licence.
Is there any other cad software of note I should keep a look out for that has good documentation?
IRIX and IRIX software discussion including open source and commerical offerings.
Any posts concerning pirated software or offering to buy/sell/trade commercial software are subject to removal.
First unread post • 2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest