I can boot sash and run fx from the CD. I can install the miniroot and get to inst. Once the installation has started, I start seeing the following errors:
Code: Select all
Reading product descriptions .. 54% WARNING: wd93 SCSI Bus = 0 ID=4 LUN = 0: SCSI cmd=0x28
timeout after 60 sec. Resetting SCSI bus
dksc0d4: Device not ready: Not ready to perform command (asc-0x4, asq=0x1)
... bunch more "not ready" lines
Too much data requested (probable SCSI bus cabling problem). Resetting SCSI bus
Has anyone had any luck with the v6 card on the wd93 controller using a CD or am I going to need to install from the network?