I have a weird problem with one of my O300 boxes. Basic config is:
6 x O300 bricks with quad 600Mhz CPUs
1 x Router
1 x L2
When system is powered on, L2 boots and will recognize all bricks, so the 'cfg' prints the address of each brick and router.
When system is booted by 'pwr u' via L2, within 10-20 seconds one of the bricks will produce following error:
Code: Select all
hub.c: USB device not accepting new address (error=-110)
SGIL1_RESET_DEVICE error, Connection timed out
WARNING: can't write to connection to 001c22 [0x0ffff00e]: IRouter:write failed
L2 SMP ERROR: no response from 001?22
usb.c: USB device not accepting new address=8 (error=-110)
hub.c: USB new device connect on bus2/1/1, assigned device number 9
usb.c: USB device not accepting new address=9 (error=-110)
hub.c: USB new device connect on bus2/1/1, assigned device number 10
The last message keeps looping forever. The brick will disappear from the inventory and will not show on L2 'cfg' output anymore.
What could be the cause for this problem?
Brick itself seems to be operational, it works fine as standalone. O300
I have checked USB and Numalink cables, replaced them, inter exchanged with other bricks e.t.c., no help