Nekochan Net

hi all

i have a sunfire v20z for check if retain it or not
so i must check if it's good

when i powerup the sistem the amber leds on font are blinkin, (wrench tool led and ID led)
lcd it's blinking also and nothing shown

internally d46 and d67 leds are blinkin'

maybe some reset trick can solve that status
i've read some pages at
http://docs.sun.com/source/817-7184-12/ts_topics.html

but i'm not expert at
so i really appreciate an help

i also tried reseatin ram sticks, checkin cables, and fully inspected inside without results.

pls help me
thx to all nekochanner can help me
bring that 1u back to life

r.

radrob@gmail.com

_________________
Coffee for the mind, pizza for the body, sushi for the soul

r7k350 r7k600 r12k400 sw1600 2x400 v10

Sounds like your v20z has gone the way of my w2100z and I suspect you have a bad motherboard such as I do (where replacing or reseating cpus / ram / video results in the same effect).

So, a side from swapping the components I have mentioned, I have no suggestions other then trying a CMOS reset.

_________________
Stuff.

uh..
yet reseated everything
i do cmos reset also
i'll try another turn of checks

it must be a PRS Internal Error
but no tips to solve it

thx anyway
r.

_________________
Coffee for the mind, pizza for the body, sushi for the soul

r7k350 r7k600 r12k400 sw1600 2x400 v10

Hmm... sounds like it's dead. If the LOM doesn't even power up then there's not much you can do with it.

_________________
[ R10k-195/MaxImpact +TRAMs/896Mb/73Gb-15krpm/G160/6.5.22 ]
[ Dual R12k-400/V8/2Gb/73Gb-15krpm/6.5.29 ]