PS3 outputting and 1080i from HDMI to a HDMI-SD convertor.
HDMI-SD convertor goes to HDi input on VBOB
VBOB HDi Output goes to SD-HDMI Convertor - TV input.
The above works fine. VBOB shows correct input
Code: Select all
HD1 is 1080i 5994
HD2 is Not Present
SD1 is Not Present
SD2 is Not Present
HD Analog in is ANALOG_TIMING_NOT_PRESENT
SD Analog in is ANALOG_TIMING_NOT_PRESENT
TV on shows correct multi-coloured test bar as expected from the VBOB that hasn't been initialized.
So I start the SMOKE and set the project to the following:
PROJECT: 1920x1080HD 1080 - 10bit Field 1 - 12bit Graphics
Start Project OK - Select Default for the source files - Select Import clip.
So I now get, TV output (ON TV) and source output on monitor.
But the problem is, no matter what I do, the source on the monitor is too big and I cannot use any of the save/modify etc buttons
You see how on image 2, the preview is over lapping, plus obviously too big for the screen.
I've tried the resize options on the previous screen, but they have no effect.
As stated, I've gone from zero knowledge on this product, and the newer documents are no help. I just need the preview to be smaller.
Any old SMOKE users out there?