So this is my first ever SGI system. Never touched one before this one or used IRIX at all.
Pretty much a childhood dream coming true to own one, tough since I really wanted one back in the day, but they where just out of reach.
Some hinv output then:
Code: Select all
2 300 MHZ IP30 Processors
Heart ASIC: Revision F
CPU: MIPS R12000 Processor Chip Revision: 2.3
FPU: MIPS R12010 Floating Point Chip Revision: 0.0
Main memory size: 256 Mbytes
Xbow ASIC: Revision 1.3
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 2 Mbytes
Integral SCSI controller 0: Version QL1040B (rev. 2), single ended
Disk drive: unit 1 on SCSI controller 0 (unit 1)
Integral SCSI controller 1: Version QL1040B (rev. 2), single ended
IOC3/IOC4 serial port: tty1
IOC3/IOC4 serial port: tty2
IOC3 parallel port: plp1
Graphics board: V6
Integral Fast Ethernet: ef0, version 1, pci 2
Iris Audio Processor: version RAD revision 12.0, number 1
PCI Adapter ID (vendor 0x10a9, device 0x0003) PCI slot 2
PCI Adapter ID (vendor 0x1077, device 0x1020) PCI slot 0
PCI Adapter ID (vendor 0x1077, device 0x1020) PCI slot 1
PCI Adapter ID (vendor 0x10a9, device 0x0005) PCI slot 3
RAM really needs to be upgraded from the 256mb currently in it.
It's an interesting machine. Have never been upgraded (except for me putting in a 146gb 15k RPM drive) to my knowledge and bought new by a school here in Sweden.
Still, it has the old Octane skins (with the full Silicon Graphics text), but Octane2 insides (PSU, motherboard etc).
Looking forward learning more about IRIX and really getting to put the Octane to some use